RES: [FUGSPBR] Bandwidth (Dinamica)

[Timmy]

mas que ip eh esse, 0x000000ff
como eu posso converter pra hexa meus ips

Frederico
On Wed, 2003-01-08 at 10:44, Bio )+(azarD wrote:
> tenta  isso por portas
> 
> #  pipeconfig:
> #    {bw|bandwidth} <number>{bit/s|Kbit/s|Mbit/s|Bytes/s|KBytes/s|MBytes/s}
> #    {bw|bandwidth} interface_name
> #    delay <milliseconds>
> #    queue <size>{packets|Bytes|KBytes}
> #    plr <fraction>
> #    mask {all| [dst-ip|src-ip|dst-port|src-port|proto] <number>}
> #    buckets <number>}
> 
> #  pipeconfig:
> #    {bw|bandwidth} <number>{bit/s|Kbit/s|Mbit/s|Bytes/s|KBytes/s|MBytes/s}
> #    {bw|bandwidth} interface_name
> #    delay <milliseconds>
> #    queue <size>{packets|Bytes|KBytes}
> #    plr <fraction>
> #    mask {all| [dst-ip|src-ip|dst-port|src-port|proto] <number>}
> #    buckets <number>}
> #    {red|gred} <fraction>/<number>/<number>/<fraction>
> #    droptail
> 
> # Traffic Shapper  porta  80  rede 192.168.33.0/28
> $IPFW add pipe 70 tcp from any to any out via ep0 keep-state
> $IPFW add pipe 80 tcp from any to any in via ep0 keep-state
> $IPFW pipe 70 config mask src-ip 0x000000ff src-port 80 bw 10KBytes/s
> $IPFW pipe 80 config mask dst-ip 0x000000ff dst-port 80 bw 20KBytes/s
> 
> veja se funciona .
> 
> 
> 
> 
> 
> 
> 
> 
> 
> 
> 
> 
> 
> 
> 
> 
> 
> 
> 
> 
> Marcello Silva Coutinho wrote:
> 
> >tente assim:
> >ipfw pipe 1 config bw 128Kbit/s queue 128Kbytes
> >ipfw pipe 2 config bw 128Kbit/s queue 128Kbytes
> >ipfw add pipe 1 ip from $ip to any
> >ipfw add pipe 2 ip from any to $ip
> >
> >
> >
> >
> >  
> >
> 
> 
> _______________________________________________________________
> Sair da Lista: http://www2.fugspbr.org/mailman/listinfo/fugspbr
> Historico: http://www4.fugspbr.org/lista/html/FUG-BR/

_______________________________________________________________
Sair da Lista: http://www2.fugspbr.org/mailman/listinfo/fugspbr
Historico: http://www4.fugspbr.org/lista/html/FUG-BR/