[FUGSPBR] Dois Cartoes com placa adaptadora Ricoh PCI

[Fbsd-mdm]

Pessoal.

Preciso de ajuda...tenho um computador com placa Soyo e colocquei duas
placas adaptadoras com dois cartoes Orinocos.
Segui o how to no site www.free.bsd.com.br e nao tem jeito das duas
funcionarem simultaneamente como cliente de dois Access Point.

Veja o dmesg:

Jul 31 12:26:33 ec-aj /kernel: config> di aic0
Jul 31 12:26:33 ec-aj /kernel: config> di aha0
Jul 31 12:26:33 ec-aj /kernel: config> di adv0
Jul 31 12:26:33 ec-aj /kernel: config> en pcic1
Jul 31 12:26:33 ec-aj /kernel: config> po pcic1 0x3e2
Jul 31 12:26:33 ec-aj /kernel: config> ir pcic1 0
Jul 31 12:26:33 ec-aj /kernel: config> iom pcic1 0xd4000
Jul 31 12:26:33 ec-aj /kernel: config> f pcic1 0
Jul 31 12:26:33 ec-aj /kernel: config> q
Jul 31 12:26:33 ec-aj /kernel: avail memory = 190668800 (186200K bytes)
Jul 31 12:26:33 ec-aj /kernel: Preloaded elf kernel "kernel" at 0xc04fc000.
Jul 31 12:26:33 ec-aj /kernel: Preloaded userconfig_script
"/boot/kernel.conf" at 0xc04fc09c.
Jul 31 12:26:33 ec-aj /kernel: Pentium Pro MTRR support enabled
Jul 31 12:26:33 ec-aj /kernel: md0: Malloc disk
Jul 31 12:26:33 ec-aj /kernel: Using $PIR table, 7 entries at 0xc00fde10
Jul 31 12:26:33 ec-aj /kernel: npx0: <math processor> on motherboard
Jul 31 12:26:33 ec-aj /kernel: npx0: INT 16 interface
Jul 31 12:26:33 ec-aj /kernel: pcib0: <Host to PCI bridge> on motherboard
Jul 31 12:26:33 ec-aj /kernel: pci0: <PCI bus> on pcib0
Jul 31 12:26:33 ec-aj /kernel: pcib2: <VIA 82C598MVP (Apollo MVP3) PCI-PCI
(AGP) bridge> at device 1.0 on pci0
Jul 31 12:26:33 ec-aj /kernel: pci1: <PCI bus> on pcib2
Jul 31 12:26:33 ec-aj /kernel: isab0: <VIA 82C596B PCI-ISA bridge> at device
7.0 on pci0
Jul 31 12:26:33 ec-aj /kernel: isa0: <ISA bus> on isab0
Jul 31 12:26:33 ec-aj /kernel: atapci0: <VIA 82C596 ATA66 controller> port
0xe000-0xe00f at device 7.1 on pci0
Jul 31 12:26:33 ec-aj /kernel: ata0: at 0x1f0 irq 14 on atapci0
Jul 31 12:26:33 ec-aj /kernel: ata1: at 0x170 irq 15 on atapci0
Jul 31 12:26:33 ec-aj /kernel: pci0: <unknown card> (vendor=0x1106,
dev=0x3050) at 7.3
Jul 31 12:26:33 ec-aj /kernel: pcic0: <Ricoh RL5C475 PCI-CardBus Bridge> mem
0xd6002000-0xd6002fff irq 15 at device 15.0 on pci0
Jul 31 12:26:33 ec-aj /kernel: pccard0: <PC Card 16-bit bus (classic)> on
pcic0
Jul 31 12:26:33 ec-aj /kernel: rl0: <RealTek 8139 10/100BaseTX> port
0xe800-0xe8ff mem 0xd6003000-0xd60030ff irq 11 at device 17.0 on pci0
Jul 31 12:26:33 ec-aj /kernel: rl0: Ethernet address: 00:e0:7d:cd:4c:e4
Jul 31 12:26:33 ec-aj /kernel: miibus0: <MII bus> on rl0
Jul 31 12:26:33 ec-aj /kernel: rlphy0: <RealTek internal media interface> on
miibus0
Jul 31 12:26:33 ec-aj /kernel: rlphy0:  10baseT, 10baseT-FDX, 100baseTX,
100baseTX-FDX, auto
Jul 31 12:26:33 ec-aj /kernel: pci0: <Alliance PMAT24 SVGA controller> at
18.0
Jul 31 12:26:33 ec-aj /kernel: pcic1: <Ricoh RL5C475 PCI-CardBus Bridge> mem
0xd6005000-0xd6005fff irq 15 at device 19.0 on pci0
Jul 31 12:26:33 ec-aj /kernel: pccard1: <PC Card 16-bit bus (classic)> on
pcic1
Jul 31 12:26:33 ec-aj /kernel: pcib1: <Host to PCI bridge> on motherboard
Jul 31 12:26:33 ec-aj /kernel: pci2: <PCI bus> on pcib1
Jul 31 12:26:33 ec-aj /kernel: orm0: <Option ROM> at iomem 0xc0000-0xc7fff
on isa0
Jul 31 12:26:33 ec-aj /kernel: fdc0: <NEC 72065B or clone> at port
0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0
Jul 31 12:26:33 ec-aj /kernel: fdc0: FIFO enabled, 8 bytes threshold
Jul 31 12:26:33 ec-aj /kernel: fd0: <1440-KB 3.5" drive> on fdc0 drive 0
Jul 31 12:26:33 ec-aj /kernel: atkbdc0: <Keyboard controller (i8042)> at
port 0x60,0x64 on isa0
Jul 31 12:26:33 ec-aj /kernel: vga0: <Generic ISA VGA> at port 0x3c0-0x3df
iomem 0xa0000-0xbffff on isa0
Jul 31 12:26:33 ec-aj /kernel: sc0: <System console> at flags 0x100 on isa0
Jul 31 12:26:33 ec-aj /kernel: sc0: VGA <16 virtual consoles, flags=0x300>
Jul 31 12:26:33 ec-aj /kernel: ppc0: parallel port not found.
Jul 31 12:26:33 ec-aj /kernel: IP packet filtering initialized, divert
enabled, rule-based forwarding enabled, default to accept, logging limited
to 100 packets/entry by default
Jul 31 12:26:33 ec-aj /kernel: DUMMYNET initialized (011031)
Jul 31 12:26:33 ec-aj /kernel: IPv6 packet filtering initialized, default to
accept, logging limited to 100 packets/entry
Jul 31 12:26:33 ec-aj /kernel: ad0: 9787MB <QUANTUM FIREBALLlct20 10>
[19885/16/63] at ata0-master UDMA66
Jul 31 12:26:33 ec-aj /kernel: Mounting root from ufs:/dev/ad0s1a
Jul 31 12:26:33 ec-aj /kernel: pccard: card inserted, slot 0
Jul 31 12:26:33 ec-aj /kernel: pccard: card inserted, slot 1
Jul 31 12:26:37 ec-aj pccardd[49]: Card "Lucent
Technologies"("WaveLAN/IEEE") [Version 01.01] [] matched "Lucent
Technologies" ("WaveLAN/IEEE") [(null)] [(null)]
Jul 31 12:26:38 ec-aj /kernel: pid 115 (rinetd), uid 0: exited on signal 10
(core dumped)
Jul 31 12:26:39 ec-aj squid[133]: Squid Parent: child process 135 started
Jul 31 12:26:42 ec-aj /kernel: wi0 at port 0x240-0x27f irq 15 slot 0 on
pccard0
Jul 31 12:26:42 ec-aj /kernel: wi0: 802.11 address: 00:02:2d:53:41:77
Jul 31 12:26:42 ec-aj /kernel: wi0: using Lucent Technologies, WaveLAN/IEEE
Jul 31 12:26:42 ec-aj /kernel: wi0: Lucent Firmware: Station 7.28.01
Jul 31 12:26:42 ec-aj pccardd[49]: wi0: Lucent Technologies (WaveLAN/IEEE)
inserted.
Jul 31 12:26:48 ec-aj squid[133]: Squid Parent: child process 172 started
Jul 31 12:26:53 ec-aj pccardd[49]: No card in database for
"(null)"("(null)")
Jul 31 12:26:53 ec-aj pccardd[49]: pccardd started

Mauro

________________________________________________
Message sent using UebiMiau 2.7.2

_______________________________________________________________
Sair da Lista: http://www2.fugspbr.org/mailman/listinfo/fugspbr
Historico: http://www4.fugspbr.org/lista/html/FUG-BR/