[FUGSPBR] Configurar o printcap para impressora Hp1200 laser

[Rogerio Heringer]

Estou com dificuldades de fazer imprimir num freebsd 4.7 , impressora hp1200
laser.
olhem o meu printcap:

#laserjet|ps|PS|S|laserjet|Hp LaserJet 1200 :\
#        :sh:sd=/var/spool/lpd/laserjet:\
#        :lp=/dev/lpt0:
lp|local line printer:\
        :sh:\
        :lp=/dev/lpt0:sd=/var/spool/output/lpd:lf=/var/log/lpd-errs:
ja tentei das 2 formas

com o lp e com o laserjet.
e com os 2 simultaneamente.
ja criei os diretorios
/var/spool/lpd/laserjet
/var/spool/lpd/lp
ja dei permissao 777 neles..
ta rodando o lpd...

o meu dmsg ta assim:

sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
sio0: type 8250
sio1: configured irq 3 not in bitmap of probed irqs 0
ppc0: <Parallel port> at port 0x378-0x37f irq 7 on isa0
ppc0: Generic chipset (NIBBLE-only) in COMPATIBLE mode
ppbus0: IEEE1284 device found /NIBBLE/ECP
Probing for PnP devices on ppbus0:
ppbus0: <Hewlett-Packard HP LaserJet 1200> PRINTER
PJL,MLC,PCL,PCLXL,POSTSCRIPT
plip0: <PLIP network interface> on ppbus0
lpt0: <Printer> on ppbus0
lpt0: Interrupt-driven port
ppi0: <Parallel I/O> on ppbus0
IP packet filtering initialized, divert enabled, rule-based forwarding
enabled,
default to accept, logging disabled
DUMMYNET initialized (011031)
da0 at ahc0 bus 0 target 1 lun 0
da0: <QUANTUM ATLAS_V__9_WLS 0230> Fixed Direct Access SCSI-3 device
da0: 40.000MB/s transfers (20.000MHz, offset 8, 16bit)
da0: 8755MB (17930694 512 byte sectors: 255H 63S/T 1116C)
da1 at ahc0 bus 0 target 2 lun 0
da1: <SEAGATE ST39236LW 0004> Fixed Direct Access SCSI-3 device
da1: 40.000MB/s transfers (20.000MHz, offset 8, 16bit)
da1: 8761MB (17942584 512 byte sectors: 255H 63S/T 1116C)
Mounting root from ufs:/dev/da0s1a
lpt0: switched to polled standard mode


alguem tem ideia do que seja??

um abraco

Rogerio Heringer

_______________________________________________________________
Sair da Lista: http://www2.fugspbr.org/mailman/listinfo/fugspbr
Historico: http://www4.fugspbr.org/lista/html/FUG-BR/